SCA_ISensor(SCA_ILogicBrick)

base class — SCA_ILogicBrick

class bge.types.SCA_ISensor(SCA_ILogicBrick)

Base class for all sensor logic bricks.

usePosPulseMode

Flag to turn positive pulse mode on and off.

Type:boolean
useNegPulseMode

Flag to turn negative pulse mode on and off.

Type:boolean
frequency

The frequency for pulse mode sensors. (Deprecated: use SCA_ISensor.skippedTicks)

Type:integer
skippedTicks

Number of logic ticks skipped between 2 active pulses

Type:integer
level

level Option whether to detect level or edge transition when entering a state. It makes a difference only in case of logic state transition (state actuator). A level detector will immediately generate a pulse, negative or positive depending on the sensor condition, as soon as the state is activated. A edge detector will wait for a state change before generating a pulse. note: mutually exclusive with tap, enabling will disable tap.

Type:boolean
tap

When enabled only sensors that are just activated will send a positive event, after this they will be detected as negative by the controllers. This will make a key thats held act as if its only tapped for an instant. note: mutually exclusive with level, enabling will disable level.

Type:boolean
invert

Flag to set if this sensor activates on positive or negative events.

Type:boolean
triggered

True if this sensor brick is in a positive state. (read-only).

Type:boolean
positive

True if this sensor brick is in a positive state. (read-only).

Type:boolean
pos_ticks

The number of ticks since the last positive pulse (read-only).

Type:int
neg_ticks

The number of ticks since the last negative pulse (read-only).

Type:int
status

The status of the sensor (read-only): can be one of these constants.

Type:int

Note

This convenient attribute combines the values of triggered and positive attributes.

reset()

Reset sensor internal state, effect depends on the type of sensor and settings.

The sensor is put in its initial state as if it was just activated.