Action Editor
The Action Editor is where you can define and control actions. It enables you to view and edit the F-Curve data-blocks you defined as Actions in the F-Curve editor. So it takes place somewhere in between the low-level F-Curves, and the high-level NLA editor.
It gives you a slightly simplified view of the F-Curve data-blocks (somewhat similar to F-Curve shown without handles). The editor can list all Action data-blocks of an object at once.
Each Action data-block forms a top-level channel (see below). Note that an object can have several Constraint (one per animated constraint) and Pose (for armatures, one per animated bone) F-Curve data-blocks, and hence an action can have several of these channels.
Header
- Layer Previous/Next (down/up arrow peak icon)
Switch between different actions stacked/stashed on top of each other in the NLA stack, without having to go to the NLA Editor and leaving tweak mode and reentering it on the other strip.
Clicking on the up/down arrow buttons to go to the action in the NLA track above/below the NLA Strip being whose action is being tweaked in the Action Editor.
If there are multiple actions/strips on the same layer/track, then only the one closest to the current frame will be used.
The operators will take into account the settings to view/edit the action in isolation (i.e. Solo and NLA Muting). This was done to make it easier to preview different stashed actions.
If moving from a solo’d NLA track to the active action, the NLA stack will be muted so that the action can be edited in isolation.
Likewise, if the NLA stack is muted when editing the action, the NLA track below it will be edited with solo enabled.
If switching between NLA Tracks, the solo status for the previous track will be transferred to the new track.
Bemerkung
These still work when you are not editing the action used by an NLA Strip. If you are just animating a new action normally, it is possible to use the down arrow button to temporarily jump down to the previous action. Without losing the new action you are working on, and then use the up arrow button to get back to it once you are done checking the other action(s).
- Action
-
- Add (Hinzufügen)
+
When an action is created it is stored in an NLA Action Stash.
- Unlink
X
When Shift-LMB clicking it clears the Fake User and removes the stashed action from the NLA stack too.
- Add (Hinzufügen)
- Push Down (strips with down arrow icon)
Adds the active action on to the NLA stack as a contributing strip. This is basically the same as pressing the Push Down button in the NLA Editor.
- Stash (snowflake icon)
Stashes the active action on to the NLA stack. i.e. it is added as a non-contributing stack in the same way that it would if you were creating a new action instead.
Bemerkung
In both of these cases (Push Down and Stash), once the action has been added to the NLA stack, it is cleared/unassigned from the active action slot (i.e. it cannot be edited anymore from the Action/Graph Editors, unless you enter „Tweak Mode“ on the corresponding strips later).