Light Settings¶

Reference

Panel:	Properties ‣ Light and Shader Editor ‣ Sidebar ‣ Settings

Next to lighting from the background and any object with an emission shader, lights are another way to add light into the scene. The difference is that they are not directly visible in the rendered image, and can be more easily managed as objects of their own type.

Common¶

Light settings for all renderers.

Eevee¶

Specular

Specular Light intensity multiplier. Use it for more artistic control. Setting this to anything but 1.0 will yield non-photorealistic result.

Custom Distance

If enabled uses Distance as the custom attenuation distance instead of global light threshold.

Distance: Specifies where light influence will be set to 0.

Shadows¶

Common Parameters¶

Clip: Distance from the light object at which the shadow map starts and ends. Any object before this distance will not appear to cast shadows. Clip End will only appear for sun lights.
Soft: Size of the filter applied to the shadow map. This filter size is independent of the shadow map resolution. Higher filter size can have a big impact on performance. There is a maximum cap to filter size (in pixels) that depends on shadow resolution.
Bias: Bias applied to the depth test to reduce self shadowing artifacts.
Exponent: Exponent applied to ESM to reduce light leaking.
Bleed Bias: Bias applied to VSM to reduce light leaking.

Contact Shadows¶

This type of shadow exists to fix light leaking caused by bias or shadow map undersampling. It uses the depth buffer to find occluders (just like Screen Space Reflections). However, just like Screen Space Reflections it has the same limitations, namely, unknown object thickness and effect disappearing at screen edges.

Tip

The distance of action of Contact Shadows should remain quite small. They are not accurate enough to shadow the entire scene.

Distance: World space distance in which to search for screen space occluder.
Softness: Controls how soft the contact shadows will be. Contact shadow blurring does not match a light’s physical size.
Bias: Bias applied to the ray tracing to reduce self-shadowing artifacts.
Thickness: Pixel thickness used to detect occlusion, treating any potential occluder as this thick.

Cascaded Shadow Map¶

These special kind of shadow maps are used by Sun lights. This is because they can shadow large scenes by distributing multiple shadow maps over the frustum range. Each cascade covers a different portion of the view frustum. Do note that cascade shadow maps are always updated because they are view dependent. This means they have a high performance impact.

Note

In orthographic view the cascades cover the whole depth range of the camera with an evenly distributed shadow precision.

Count: Number of cascades to use. More cascades means better precision but a lower update rate.
Fade: Fade transition area between two cascades. Higher values means less overall resolution because cascades need to overlap.
Max Distance: Distance away from the view origin (or camera origin if in camera view) to cover by the cascade. If the view far clip distance is lower than Max Distance, the lowest of the two will be used. Only works in perspective view.
Distribution: Puts more resolution towards the near clip plane. Only works in perspective view.

Limitations¶

Unlike in Cycles, the Size of spot lights does not change the softness of the cone.