Multiplane Scrape

Reference

Mode:

Sculpt Mode

Tool:

Toolbar ‣ Multiplane Scrape

Scrapes the mesh with two angled planes at the same time, creating a sharp edge between them. This is useful for creating & polishing hard surface objects.

Brush Settings

General

Note

More info at General brush settings and on Advanced brush settings.

Unique

Plane Angle

The angle between the two planes of the brush, pressing Ctrl inverts the angle.

Dynamic Mode

When enabled, the angle is dynamically updated based on the surface under the brush. The Plane Angle then controls how much the angle will increase when applying pen pressure. When pressing Ctrl, it locks the plane angle to 0 degrees.

Show Cursor Preview

Displays a preview of the two planes and the angle they form during the stroke.