Build Modifier
The Build modifier make strokes appear or disappear in a frame range to create the effect of animating lines being drawn or erased.
Options
- Mode
Determines how many strokes are being animated at a time.
- Sequential
Strokes appear/disappear one after the other, but only a single one changes at a time.
- Concurrent
Multiple stroke appear/disappear at a time.
If enabled you can set the Time Alignment.
- Time Alignment
- Align Start
All stroke start at the same time (i.e. shorter strokes finish earlier).
- Align End
All stroke end at the same time (i.e. shorter strokes start later).
- Transition
Determines the animation type to build the strokes.
- Grow
Shows points in the order they occur in each stroke, from first to last stroke. (Simulating lines being drawn.)
- Shrink
Hide points from the end of each stroke to the start, from last to first stroke. (Simulating lines being erased.)
- Fade
Hide points in the order they occur in each stroke, from first to last stroke. (Simulating ink fading or vanishing after getting drawn.)
- Start Delay
Number of frames after each Grease Pencil keyframe before the modifier has any effects.
- Frames
Maximum number of frames that the build effect can run for. (Unless another Grease Pencil keyframe occurs before this time has elapsed.)
- Factor
Use a defined percentage factor to control the amount of the stroke that is visible.
- Object
Object to use as the start position of the build transition.
Custom Range
If enabled, only modify strokes during the specified frame range.
- Awal, Akhir
Determines the start and end frame for the build effect.
Fade
- Factor
Defines home much the stroke is fading in/out.
- Thickness
How much strength fading is applied to the stroke's thickness.
- Opacity
How much strength fading applies to the stroke's opacity.
- Weight Output
Assign a weight value to points that have started/finished the fade.
Influence Filters
See Influence Filters.