Selezione
Selection tools are available in the Select Menu in the header, and the shortcuts listed below.
Sync Selection
Turning on the Sync Selection button causes selection of components in the 3D Viewport to sync with their corresponding elements in the UV editor. If off only the selected faces are displayed in the UV editor. These two modes have very different results when transforming components in the UV editor.
Vedi anche
Modalità di Selezione
Select Modes dependent on the Sync Selection.
Sync Selection Off
- Vertice
Select individual vertices.
- Bordo
Select edges.
- Faccia
Select faces.
- Isola
Select contiguous groups of faces.
Sync Selection On
When selecting UVs or Edges, it behaves like the Shared Vertex option of the Sticky Selection Mode. When selecting Faces, it behaves like the Disabled option of the Sticky Selection Mode.
- Vertice
Select individual vertices.
- Bordo
Select edges.
- Faccia
Select faces.
Modalità di Selezione Adesiva
This selector lets you enable automatic additional selection.
- Vertice Condiviso
Selects UVs that share a mesh vertex, even if they are in different UV locations.
- Posizione Condivisa
Selects UVs that are in the same UV location and share a mesh vertex.
- Disabilitato
Disables Sticky Selection. When you move a UV in this mode, each face owns its own UVs, allowing them to be separated.
Shortest Path
Riferimento
- Modalità
Modalità Modifica
- Menù
- Scorciatoia
Trova Nodo Ctrl-F
Selects all UV components along the shortest path from the active component to the one which was selected.
- Face Stepping
Supports diagonal paths for vertices and faces, and selects edge rings with edges.
- Topological Distance
Only takes into account the number of edges of the path and not the length of the edges to calculate the distances.
- Fill Region Shift-Ctrl-LMB
Selects all elements in the shortest paths from the active selection to the clicked area.
- Checker Deselect Options
Allows to quickly select alternate elements in a path.
- Deselected
The number of deselected elements in the repetitive sequence.
- Selected
The number of selected elements in the repetitive sequence.
- Scostamento
Offset from the starting point.
Vedi anche
Mesh edit Select Shortest Path.
Select Edge Loops
Riferimento
- Modalità
Modalità Modifica
- Scorciatoia
Ctrl-Alt-LMB, or Shift-Ctrl-Alt-LMB for modifying existing selection.
Holding Ctrl-Alt while selecting a UV component selects a loop of edges that are connected in a line end-to-end, passing through the edge under the mouse pointer. Holding Shift-Ctrl-Alt while clicking adds to the current selection.
Vedi anche
Mesh edit Select Edge Loops.