Hiding & Masking¶
While sculpting, areas might be hidden behind parts of the mesh or they might be too close to other parts. To work through these, it is useful to isolate parts of a mesh to sculpt on. This can be done by either completely hiding parts of the mesh or by masking areas that can not be sculpted on.
Portions of the mesh can be hidden in Sculpt Mode to improve performance and to access parts of the mesh that would otherwise be difficult to access, because they are occluded by other parts.
The hidden faces cannot be sculpted on. Hiding is shared between Edit Mode and Sculpt Mode (i.e. hiding/unhiding in one mode affects the other mode too).
- Hide Bounding Box H
- To hide a part of a mesh inside the selection. This works similar to Border Select tool.
- Hide Bounding Box Shift-H
- To reveal a hidden part of a mesh inside the selection.
- Show All Alt-H
- Reveal all hidden parts.
- Hide Masked
- Hides all masked vertices.
Masking to control which areas of the mesh are influenced by sculpting.
In order to edit the mask, select the Mask Brush from the Brush panel.
Masks can be edited across the entire model:
- Invert Mask Ctrl-I
- Inverts an existing mask.
- Fill Mask
- Fills the whole mask with a value of 1.
- Clear Mask Alt-M
- Fills the mask with a value of 0. To completely remove the mask data see Clearing Mask Data.
- Box Mask B
- Works like the Border Select tool, it creates a rectangular mask region. Hold Shift to clear the mask of the selected region.
- Lasso Mask Shift-Ctrl-LMB
Can be used to create a free-form mask, similar to the Lasso Select tool.
To clear the mask of areas with the Lasso Mask tool, first invert the mask, apply the Lasso Mask, and then invert the mask back.
Clearing Mask Data¶
Completely frees the mask data layer from the mesh, while not a huge benefit, this can speed-up sculpting if the mask is no longer being used.