Sculpt
This page details the general hotkey operators and menu operators in sculpt mode.
Show & Hide
Some very common hotkey operators to control the visibility based on face sets. These are not part of any menu and have to be used via the shortcuts. More visibility operators can be found in the Face Sets Menu and the Pie Menu shortcut W. (Since visibility is often toggled via face sets.)
- Toggle Visibility H
Hide all face sets except the active one (under the cursor). If face sets are already hidden, then this operator will show everything.
- Hide Active Face Set Shift-H
Hide the face set under the cursor. Press H afterwards to show everything.
Примечание
These two shortcuts are inverted compared to other modes, to make the operators more convenient to access. Toggling the Visibility is far more often used. If this behavior is undesired it’s recommended to change the keymap in the preferences.
Справка
- Mode:
Sculpt Mode (режим скульптинга)
- Меню:
- Show All W, Alt-H
Reveal all hidden faces.
- Show Bounding Box
Draw a box to reveal hidden faces. This works similar to the Box Select tool.
- Hide Bounding Box
Draw a box to hide faces of a mesh.
- Hide Masked
Hides all masked vertices.
См.также
For a more general introduction see Visibility, Masking & Face Sets.
Set Pivot
Справка
- Mode:
Sculpt Mode (режим скульптинга)
- Меню:
Like Object and Edit Mode, Sculpt Mode also has a Pivot Point. This is because the basic move, rotate and scale transforms are also supported in Sculpt Mode. But the pivot point in Sculpt Mode is unique. It always moves together with the transformed mesh and can be both manually & automatically placed.
- Origin (исходная точка)
Sets the pivot to the origin of the sculpt.
- Unmasked
Sets the pivot position to the average position of the unmasked vertices.
- Mask Border
Sets the pivot position to the center of the mask’s border. This operation will automatically happen when using Expand.
- Active Vertex
Sets the pivot position to the active vertex position.
- Surface (поверхность)
Sets the pivot position to the surface under the cursor.
Совет
For more convenient placement of the pivot point it’s recommended to assign a shortcut to either Surface or Active Vertex.
См.также
For a more general introduction see Transforming.
Transfer Sculpt Mode
Справка
- Mode:
Sculpt Mode (режим скульптинга)
- Меню:
- Горячая клавиша:
Alt-Q
Switches Sculpt Mode from the Active object to the object under the mouse. See Switching Objects for more information.
См.также
For a more general introduction see Working with Multiple Objects.
Rebuild BVH
Справка
- Mode:
Sculpt Mode (режим скульптинга)
- Меню:
Recalculates the BVH used by Dyntopo to improve performance, which might degrade over time while using Dyntopo.
См.также
For a more general introduction see Adaptive Resolution.