Crop Node

Crop Node.

The Crop node crops an input image to a selected region by either making the cropped area transparent or by resizing the input image.

Входы

Image

Standard color input. If no image is selected, an image filled with the selected color is used. You can use and crop this image in combination with another background image.

Свойства

Crop Image Size

When disabled, the image remains the same size, but the cropped areas become transparent pixels. When enabled, the image size is cropped to the specified region and gets a new width or height or both.

Note that this will probably reposition the image in the render output because the cropped image is automatically centered.

Relative

When enabled, crop dimensions are a percentage of the input image’s width and height. When disabled, the range of the Crop Region Values are the width and height of the image in pixels.

Crop Region Values

Define borders of the crop region; Left or Right can vary between 0 and the width of the image. Up or Down can vary between 0 and the height of the image.

Примечание

The terminology (Left, Right, Up, Down) can be misunderstood easily. First, the numbers do not represent the amount of cropping, e.g. Left is set to 50 and Right to 50 does not mean that you will be cropping the image for 50 pixels on both the left and right side. In fact, it will result in zero-sized image because you are cropping from pixel 50 to pixel 50. So, the numbers defines a position in the input image.

Secondly, depending on which one is bigger, Left should be interpreted as Right and vice versa. If Left is greater than Right then both values are switched and Left gets the value of Right and vice versa. The same operation is done for Up and Down, where you can think of them as the top and bottom of the image.

Thirdly, the terms Up and Down are ambiguous and suggest an action; e.g. «Crop down». The values, however, are not amounts but positions. The term Down should be interpreted as «Bottom» and Up as «Top».

Выходы

Image

Standard color output.

Использование

The following workflow removes some possible confusion:

  1. Uncheck Crop Image Size for this step, so that you can see the borders of the input image. To see this border, you have to select the Viewer node.

  2. If you don’t need pixel-perfect cropping, check Relative so that you do not have to consider the exact dimensions of the input image.

  3. Set Left and Down to zero. Set Right and Up to one, or to the width and height of the input image. You should see now the entire input image in the backdrop. Up is thus interpreted as the top of the image. The origin of the image (0, 0) is at the bottom (down) left corner.

  4. To crop from the left, change the Left value. To crop from the right, change the Right value. To crop from the top, change the Up value. To crop from the bottom, change the Down value.