Polyline Tool

Sklic

Način

Draw Mode

Tool

Toolbar ‣ Polyline

The Polyline tool create multiple straight lines.

Tool Settings

You can configure the brush main settings exposed on the Tool Settings for convenience. For the draw brushes configuration and settings see: Draw Brush.

Subdivisions

The number of stroke points between each stroke edge.

Thickness Profile

Use a curve widget to define the stroke thickness from the start (left) to end (right) of the stroke.

Use Curve

When enabled, the stroke use a curve profile to control the thickness along the line.

Different thickness profile samples.
../../../../_images/grease-pencil_modes_draw_tools_polyline_thickness-profile-01.png
../../../../_images/grease-pencil_modes_draw_tools_polyline_thickness-profile-02.png
../../../../_images/grease-pencil_modes_draw_tools_polyline_thickness-profile-03.png

Usage

Selecting a Brush and Material

In the Tool Settings select the brush, material and color type to use with the tool. The Line tool uses Draw Brush types. See Brush Settings for more information.

Creating Polylines

  1. Click (LMB or the Pen tip) and drag the start point.

  2. Release on the desired end point.

  3. Click multiple times on different locations to create multiple connected lines.

  4. Then confirm (Return/MMB) or cancel (Esc/RMB).

While dragging you can use Shift to snapping the line to horizontal, vertical or 45° angle.

NumpadPlus and NumpadMinus or using the mouse Wheel will increase or decrease the amount of points in the final line.

../../../../_images/grease-pencil_modes_draw_tools_polyline_example-01.png

click and dragging the start point.

../../../../_images/grease-pencil_modes_draw_tools_polyline_example-02.png

Click multiple times to create multiple connected lines.

../../../../_images/grease-pencil_modes_draw_tools_polyline_example-03.png

The polyline after confirming.