Sample Curve Node


Sample Curve node.

The Sample Curve calculates a point on a curve at a certain distance from the start of the curve, specified by the length or factor inputs. It also outputs data retrieved from that position on the curve. The sampled values are linearly interpolated from the values at the evaluated curve points at each side of the sampled point.


When the curve contains multiple splines, the sample position is found based on the total accumulated length, including the lengths of all previous splines. The order of the splines is the same order as displayed in the Spreadsheet Editor.

Inputs – Уводи

Curve – Крива

Standard geometry input with a curve component.

Factor – Фактор

The portion of the total length used to determine the sample position.

Довжина – Length

A length in distance units used to determine how far along the curve to travel before sampling.

Властивості – Properties

Режим – Mode

How to find endpoint positions for the trimmed spline. The option acts the same as it does in the Trim Curve Node.

Factor – Фактор

Find the endpoint positions using a factor of each spline’s length. The input values should be between 0 or 1.

Довжина – Length

Find the endpoint positions using a length from the start of each spline. The input values should be between 0 and the length of the splines.

Outputs – Виводи

Position – Позиція

The position at the sample along the spline.

Tangent – Тангенс

The normalized curve tangent at the sample.


This output can be combined with the Align Euler to Vector Node to create a rotation that lines up with direction of the curve. Including the Normal output in a second align node after can align the other rotation axis.

Normal – Нормаль

The normalized curve normal at the sample.

Приклади – Examples


Here, the Count mode of the Resample Curve Node is recreated, except a mesh is used for the result instead of a curve. The Z axis of the position can be used as the sample factor because the position is between zero and one for the entire line.