Active Spline

Referenz

Modus

Edit Mode

Menü

Properties ‣ Curve ‣ Active Spline

The Active Spline panel is used in Edit Mode to control properties of the currently selected spline.

Common Options

Cyclic U

Closes the active spline.

../../../_images/modeling_curves_properties_active-spline_nurbs-default.png

Default NURBS curve.

../../../_images/modeling_curves_properties_active-spline_nurbs-cyclic.png

A NURBS curve with Cyclic applied.

Resolution U

Alters the resolution of each segment by changing the number of subdivisions.

Smooth

Use Smooth Shading for any 3D geometry.

Poly

../../../_images/modeling_curves_properties_active-spline_panel-poly.png

Active Spline panel: Poly Spline.

Cyclic U

See Common Options.

Smooth

See Common Options.

Bézier

../../../_images/modeling_curves_properties_active-spline_panel-bezier.png

Active Spline panel: Bézier Spline.

Cyclic U

See Common Options.

Resolution U

See Common Options.

Interpolation Tilt

Alters how the tilt of a segment is calculated.

Radius

Alters how the radius of a beveled curve is calculated. The effects are easier to see after increasing the radius.

Smooth

See Common Options.

NURBS

One of the characteristics of a NURBS object is the knot vector. This is a sequence of numbers used to determine the influence of the control points on the curve. While you cannot edit the knot vectors directly, you can influence them through the Endpoint and Bézier options in the Active Spline panel. Note that, the Endpoint and Bézier settings only apply to open NURBS curves.

../../../_images/modeling_curves_properties_active-spline_panel-nurbs.png

Active Spline: NURBS Spline.

Cyclic U

See Common Options.

Bézier U

Makes the NURBS curve act like a Bézier curve. The NURBS control points act like Free handles of Bézier curve. Depending on the Order, 3 or 4 control points form one curve segment. Cyclic and Endpoint must be disabled for this option to work.

Endpoint U

Makes the curve contact the end control points. Cyclic must be disabled for this option to work.

../../../_images/modeling_curves_properties_active-spline_nurbs-default.png

Default NURBS curve.

../../../_images/modeling_curves_properties_active-spline_nurbs-endpoint.png

A NURBS curve with Endpoint enabled.

Order U

The order of the NURBS curve determines the area of influence of the control points over the curve. Higher order values means that a single control point has a greater influence over a greater relative proportion of the curve. The valid range of Order values is 2-6 depending on the number of control points present in the curve.

../../../_images/modeling_curves_properties_active-spline_nurbs-default.png

NURBS curves with orders of 4.

../../../_images/modeling_curves_properties_active-spline_nurbs-order.png

NURBS curves with orders of 2.

Resolution U

See Common Options.

Smooth

See Common Options.