Seleccionar Vinculado

Linked

Referencia

Modo

Modo Edición

Menú

Select ‣ Select Linked ‣ Linked

Atajo

Ctrl-L

Select geometry connected to already selected elements. This is often useful when a mesh has disconnected, overlapping parts, where isolating it any other way would be tedious. To give more control, you can also enable delimiters in the Ajustar la Última Operación panel, so the selection is constrained by seams, sharp edges, materials or UV islands.

With Pick Linked you can also select connected geometry directly under the cursor, using the L shortcut to select or Shift-L to deselect linked. This works differently in that it uses the geometry under the cursor instead of the existing selection.

Shortest Path (Ruta Más Corta)

Referencia

Modo

Modo Edición

Menú

Select ‣ Select Linked ‣ Shortest Path

Atajo

Ctrl-LMB

../../../_images/modeling_meshes_selecting_linked_shortest-path.png

Select a face or vertex path with Ctrl-LMB.

Selects all geometry along the shortest path from the active vertex, edge, or face to the one which was selected.

Edge Tag (in Edge select mode only)

This select button indicates what should be done when selecting a vertex path with Ctrl-LMB:

Seleccionar

Just selects all the edges in the path.

Tag Seam

Marks all edges in the path as seams for UV unwrapping.

Tag Sharp

Marks all edges in the path as sharp for the Edge Split Modifier.

Tag Crease

Marks all edges in the path as creases for the Subdivision Surface Modifier, with weight 1.0.

Tag Bevel

Gives bevel weight 1.0 (for the Bevel Modifier) to all edges in the path.

Tag Freestyle Edge Mark

Marks all edges in the path as Freestyle edges.

Face Stepping (Paso por Caras)

Soporta rutas diagonales para vértices y caras, y selecciona anillos de aristas con aristas.

Topological Distance (Distancia Topológica)

Solo toma en consideración el número de aristas de la ruta y no la longitud de las aristas para calcular las distancias.

Fill Region (Llenar Región) Shift-Ctrl-LMB

Selecciona todos los elementos en las rutas más cortas desde la selección activa hasta el área sobre la que se hace clic.

Checker Deselect Options (Opciones de Deselección de Cuadrícula)

Permite seleccionar rápidamente elementos alternos en una ruta.

Deselected (Deseleccionados)

El número de elementos deseleccionados en la secuencia repetitiva.

Selected (Seleccionados)

El número de elementos seleccionados en la secuencia repetitiva.

Offset

Desplazamiento desde el punto de inicio.

Linked Flat Faces

Referencia

Modo

Modo Edición

Menú

Select ‣ Select Linked ‣ Linked Flat Faces

Selects all connected faces with a similar angle.

Sharpness

Select connected faces with a reference angle less than the value specified.

../../../_images/modeling_meshes_selecting_linked_flat-faces.png

Looking at the image above, when at least one face is selected (as seen on the left), Linked Flat Faces will select all connecting faces that lie on the same or similar plane (as shown in the middle image). If the corners are smoothed, those faces are no longer lined up with the selected faces. At this point, increasing the Sharpness value in the tool options could include the smoothed faces.