Seleccionar Vinculado
Vinculados
Referencia
- Modo
Modo Edición
- Menú
- Atajo
Ctrl-L
Select geometry connected to already selected elements. This is often useful when a mesh has disconnected, overlapping parts, where isolating it any other way would be tedious. To give more control, you can also enable delimiters in the Ajustar Última Operación panel, so the selection is constrained by seams, sharp edges, materials or UV islands.
With Pick Linked you can also select connected geometry directly under the cursor, using the L shortcut to select or Shift-L to deselect linked. This works differently in that it uses the geometry under the cursor instead of the existing selection.
Camino Más Corto
Referencia
- Modo
Modo Edición
- Menú
- Atajo
Ctrl-LMB
Select a face or vertex path with Ctrl-LMB.
Selects all geometry along the shortest path from the active vertex, edge, or face to the one which was selected.
- Edge Tag (in Edge select mode only)
This select button indicates what should be done when selecting a vertex path with Ctrl-LMB:
- Seleccionar
Just selects all the edges in the path.
- Tag Seam
Marks all edges in the path as seams for UV unwrapping.
- Tag Sharp
Marks all edges in the path as sharp for the Edge Split Modifier.
- Tag Crease
Marks all edges in the path as creases for the Subdivision Surface Modifier, with weight 1.0.
- Tag Bevel
Gives bevel weight 1.0 (for the Bevel Modifier) to all edges in the path.
- Tag Freestyle Edge Mark
Marks all edges in the path as Freestyle edges.
- Intervalo de Caras
Soporta rutas diagonales para vértices y caras y selecciona anillos de aristas con aristas.
- Distancia Topológica
Sólo toma en consideración el número de aristas de la ruta y no la longitud de las aristas para calcular las distancias.
- Rellenar Región Mayús-Ctrl-LMB
Selecciona todos los elementos en las rutas más cortas desde la selección activa hasta el área sobre la que se hace clic.
- Verificador de Opciones de Deselección
Permite seleccionar rápidamente elementos alternos en una ruta.
- Deseleccionados
El número de elementos deseleccionados en la secuencia repetitiva.
- Seleccionado
El número de elementos seleccionados en la secuencia repetitiva.
- Desplazamiento
Desplazamiento desde el punto de inicio.
Linked Flat Faces
Referencia
- Modo
Modo Edición
- Menú
Selects all connected faces with a similar angle.
- Sharpness
Select connected faces with a reference angle less than the value specified.
Looking at the image above, when at least one face is selected (as seen on the left), Linked Flat Faces will select all connecting faces that lie on the same or similar plane (as shown in the middle image). If the corners are smoothed, those faces are no longer lined up with the selected faces. At this point, increasing the Sharpness value in the tool options could include the smoothed faces.