Editing
Transform
Untuk melakukan.
Snap
Untuk melakukan.
Bake Action
Reference
- Editor
Nonlinear Animation
- Menu
Reference
- Editor
3D Viewport
- Mode
Object and Pose Modes
- Menu
The final motion of objects or bones depends not only on the keyframed animation, but also on any active F-Curve modifiers, drivers, and constraints. On each frame of all the scene's frames, the Bake Action operator computes the final animation of the selected objects or bones with all those modifiers, drivers, and constraints applied, and keyframes the result.
This can be useful for adding deviation to a cyclic action like a Walk Cycle, or to create a keyframe animation created from drivers or constraints.
Duplicate
Reference
- Menu
Creates a new instance of the selected strips with a copy of the action.
Linked Duplicate
Reference
- Menu
- Shortcut
Alt-D
The contents of one Action strip can be instanced multiple times. To instance another strip, select a strip, go to
. It will uses the same action as the selected strips.Now, when any strip is tweaked, the others will change too. If a strip other than the original is tweaked, the original will turn to red.
Split Strips
Untuk melakukan.
Delete Strips
Untuk melakukan.
Delete Tracks
Untuk melakukan.
Toggle Muting
Untuk melakukan.
Apply Scale
Untuk melakukan.
Clear Scale
Untuk melakukan.
Sync Action Length
Untuk melakukan.
Make Single User
Reference
- Menu
- Shortcut
U
This tool ensures that none of the selected strips use an action which is also used by any other strips.
Catatan
This does not recursively go inside meta strips.
Swap Strips
Untuk melakukan.
Move Strips Up
Untuk melakukan.
Move Strips Down
Untuk melakukan.
Track Ordering
Untuk melakukan.
Remove Empty Animation Data
Reference
- Menu
This operator removes AnimData data-blocks (restricted to only those which are visible in the animation editor where it is run from) which are "empty" (i.e. that is, have no active action, drivers, and NLA tracks or strips).
It is sometimes possible to end up with a lot of data-blocks which have old and unused Animation Data containers still attached. This most commonly happens when doing motion graphics work (i.e. when some linked-in objects may have previously been used to develop a set of reusable assets), and is particularly distracting in the NLA Editor.
Start Editing Stashed Action
Reference
- Menu
- Shortcut
Shift-Tab
It will enter and exit Tweak Mode as usual, but will also make sure that the action can be edited in isolation (by flagging the NLA track that the action strip comes from as being "solo"). This is useful for editing stashed actions, without the rest of the NLA Stack interfering.
When you finished editing the strip, simply go to
or press Shift-Tab.Start Tweaking Strips Actions (Full Stack)
Reference
- Menu
Allows you to edit the contents of the strip without disabling all the tracks above the tweaked strip. This allows keyframing to work as expected, and preserves the pose that you visually keyed.
When you finished editing the strip, simply go to
or press Tab.Catatan
For transitions above the tweaked strip, keyframe remapping will fail for channel values that are affected by the transition. A work around is to tweak the active strip without evaluating the upper NLA stack.
Start Tweaking Strips Actions (Lower Stack)
Reference
- Menu
- Shortcut
Tab
The contents of Action strips can be edited, but you must be in Tweak Mode to do so. The keyframes of the action can then be edited in the Dope Sheet.
When you finished editing the strip, simply go to
or press Tab.