Line Project
参照
- Mode(モード)
Sculpt Mode(スカルプトモード)
- Tool(ツール)
This tool flattens the geometry along a plane determined by the camera view and a drawn line. The region of the mesh being flattened is visualized by the side of the line that is shaded.
Tool Settings(ツールの設定)
- Limit to Segment
Apply the gesture action only to the area that is contained within the segment without extending its effect to the entire line.
使用方法
Orient the 3D Viewport to define the local view plane to use for the Boolean.
LMB and hold while moving the cursor to define the line to pick a region of the view plane to remove.
Release LMB to confirm.
コントロール
- Flip(反転) F
Changes the side of the line that the tool removes geometry.
- Snap(スナップ) Ctrl
ラインの回転を15度間隔に制限します。
- Move(移動) Ctrl-Spacebar
線の位置を変更します。