Модификатор Build
Модификатор заставляет грани объекта сетки появляться или исчезать одна за другой с течением времени.
См.также
This documentation refers to the Build Modifier specific to the Grease Pencil object. For uses with other object types refer to the general Модификатор Build.
Параметры
Модификатор Build.
- Mode
Determines how many strokes are being animated at a time.
- Sequential
Strokes appear/disappear one after the other, but only a single one changes at a time.
- Concurrent
Multiple stroke appear/disappear at a time.
If enabled you can set the Time Alignment.
- Time Alignment
- Align Start
All stroke start at the same time (i.e. shorter strokes finish earlier).
- Align End
All stroke end at the same time (i.e. shorter strokes start later).
- Transition
Determines the animation type to build the strokes.
- Grow
Shows points in the order they occur in each stroke, from first to last stroke. (Simulating lines being drawn.)
- Shrink
Hide points from the end of each stroke to the start, from last to first stroke. (Simulating lines being erased.)
- Fade
Hide points in the order they occur in each stroke, from first to last stroke. (Simulating ink fading or vanishing after getting drawn.)
- Start Delay
Number of frames after each Grease Pencil keyframe before the modifier has any effects.
- Frames (кадры)
Maximum number of frames that the build effect can run for. (Unless another Grease Pencil keyframe occurs before this time has elapsed.)
- Factor
Use a defined percentage factor to control the amount of the stroke that is visible.
- Object (объект)
Object to use as the start position of the build transition.
Custom Range
If enabled, only modify strokes during the specified frame range.
- Start, End
Determines the start and end frame for the build effect.
Fade
- Factor
Defines home much the stroke is fading in/out.
- Толщина
How much strength fading is applied to the stroke’s thickness.
- Opacity (непрозрачность)
How much strength fading applies to the stroke’s opacity.
- Weight Output
Assign a weight value to points that have started/finished the fade.
Influence Filters
See Influence Filters.