Cloth

Sklic

Način

Sculpt Mode

Tool

Toolbar ‣ Cloth

The Cloth brush uses a simplified Cloth Solver to simulate cloth physics on the mesh under the brush. Masked vertices are pinned in the simulation, and it applies the sculpt gravity directly in the solver. Note, using a relatively small brush makes the solver’s calculations much faster, larger brush sizes might be too slow to get a usable brush.

Brush Settings

Persistent

Allows the cloth brush to not accumulate deformation after each stroke. This is convenient to always simulate the based on the same initial shape, but applying different forces to it.

When disabled, deformations accumulate after each stroke.

Set Persistent Base

Resets the base mesh so that you can add another layer of deformations.

Simulation Area

Selects the part of the mesh that is going to be simulated when the stroke is active. This can greatly affect performance depending on the complexity of the mesh.

Local

Simulates only a specific area around the brush limited by a fixed radius.

Global

Simulates the entire mesh.

Dynamic

The active simulation area moves with the brush while still being limited by a fixed radius.

Simulation Limit

The Factor added relative to the size of the radius to limit the cloth simulation effects.

Simulation Falloff

The area to apply deformation falloff to the effects of the simulation. This setting is a factor of the Simulation Limit and is shown as a dashed line around the cursor.

Pin Simulation Boundary

Lock the position of the vertices in the simulation falloff area to avoid artifacts and create a softer transition with unaffected areas.

Deformation

The type of cloth deformation that is used by the brush.

Drag

Simulates pulling the cloth to the cursor, similar to placing a finger on a table cloth and pulling.

Push

Simulates pushing the cloth away from the cursor, similar to placing a finger on a table cloth and pushing.

Pinch Point

Simulates pulling the cloth into a point.

Pinch Perpendicular

Simulates pulling the brush into a line.

Inflate

Simulates air being blown under the cloth so that the cloth lifts up.

Grab

Simulates picking up and moving the cloth.

Expand

Simulates stretching the cloth out.

Snake Hook

Simulates moving the cloth without producing any artifacts in the surface and creates more natural looking folds than any of the other deformation modes. This is accomplished by adjusting the strength of the deformation constraints per brush step to avoid affecting the results of the simulation as much as possible.

Force Falloff

Shape used in the brush to apply force to the cloth.

Radial

Applies the force as a sphere.

Plane

Applies the force as a plane.

Cloth Mass

Mass of each simulation particle.

Cloth Damping

How much the applied forces are propagated through the cloth.

Soft Body Plasticity

The amount the cloth preserves its original shape, acting as a Soft Body.

Use Collisions

Enables the detection of collisions with other objects during the simulation. In order for the sculpt object to collide with objects, the collision object must have Collision Physics activated.