Generic Spring Constraint
Reference – Довідка
- Panel – Панель
«Фізика > Примус Твердого Тіла» –
- Type – Тип
Узагальнена Пружність – Generic Spring
The generic spring constraint adds some spring parameters for the X/Y/Z axes to all the options available on the Generic constraint. Using the spring alone allows the objects to bounce around as if attached with a spring anchored at the constraint object. This is usually a little too much freedom, so most applications will benefit from enabling translation or rotation constraints.
If the damping on the springs is set to 1, then the spring forces are prevented from realigning the anchor points, leading to strange behavior. If your springs are acting weird, check the damping.
Options – Опції
- Ліміти – Limits
- Вісь X/Y/Z – X/Y/Z Axis
Вмикає/вимикає лімітування пересування по осях X, Y або Z відповідно.
- Нижнє – Lower
Нижній ліміт пересування для осей X, Y або Z відповідно.
- Верхнє – Upper
Верхній ліміт пересування для осей X, Y або Z відповідно.
- Кут X/Y/Z – X/Y/Z Angle
Вмикає/вимикає лімітування обертання навколо осей X, Y або Z відповідно.
- Нижнє – Lower
Нижній ліміт обертання навколо осей X, Y або Z відповідно.
- Верхнє – Upper
Верхній ліміт обертання навколо осей X, Y або Z відповідно.
- Пружності – Springs
- Вісь X/Y/Z – X/Y/Z Axis
Вмикає/вимикає лімітування пружинного пересування по осях X, Y або Z відповідно.
- Stiffness – Тугість
Spring Stiffness of the translation on X, Y or Z axis respectively. Specifies how «bendy» the spring is.
- Згасання – Damping
Spring Damping of the translation on X, Y or Z axis respectively. Amount of damping the spring has.
- Кут X/Y/Z – X/Y/Z Angle
Вмикає/вимикає лімітування пружинного обертання навколо осей X, Y або Z відповідно.
- Stiffness – Тугість
Spring Stiffness of the rotation around the X, Y or Z axis respectively. Specifies how «bendy» the spring is.
- Згасання – Damping
Spring Damping of the rotation around the X, Y or Z axis respectively. Amount of damping the spring has.