Cone Node

The Cone node generates a cone mesh that is optionally truncated.

输入

顶点: Number of points on the circle at the top and bottom. No geometry is generated if the number is below three.
Side Segments: Number of edges running vertically along the side of the cone. No geometry is generated if the number is below one.
Fill Segments: Number of concentric rings used to fill the round faces at the top and bottom. No geometry is generated if the number is below one.
半径顶部(Radius Top): The distance of the vertices in the top circle from the Z axis. If this is zero, the vertices in the circle are merged into one.
半径底部(Radius Bottom): Same as Radius Top but for the bottom circle.
深度: Height of the generated cone.

Note

If the top and bottom radii are zero, this node will output a single line.

填充类型

How the circles at the top and bottom are filled with faces when their radius is larger than zero.

无: Do not fill the circles.
多边形: Fill the innermost segment of the circles with a single face.
三角形: Fill the innermost segment of the circles with triangles connected to a new vertex on the Z axis.