Curva Activa
Referencia
- Modo
Modo Edición
- Menú
The Active Spline panel is used in Edit Mode to control properties of the currently selected spline.
Opciones comunes
- Cyclic U
Closes the active spline.
Default NURBS curve.
A NURBS curve with Cyclic applied.
- Resolution U
Alters the resolution of each segment by changing the number of subdivisions.
- Suavizado
Use Smooth Shading for any 3D geometry.
Polígono

Active Spline panel: Poly Spline.
- Cyclic U
See Common Options.
- Suavizado
See Common Options.
Bézier

Active Spline panel: Bézier Spline.
- Cyclic U
See Common Options.
- Resolution U
See Common Options.
- Interpolation Tilt
Alters how the tilt of a segment is calculated.
- Radio
Alters how the radius of a beveled curve is calculated. The effects are easier to see after increasing the radius.
- Suavizado
See Common Options.
NURBS
One of the characteristics of a NURBS object is the knot vector. This is a sequence of numbers used to determine the influence of the control points on the curve. While you cannot edit the knot vectors directly, you can influence them through the Endpoint and Bézier options in the Active Spline panel. Note that, the Endpoint and Bézier settings only apply to open NURBS curves.

Active Spline: NURBS Spline.
- Cyclic U
See Common Options.
- Bézier U
Makes the NURBS curve act like a Bézier curve. The NURBS control points act like Free handles of Bézier curve.
- Endpoint U
Makes the curve contact the end control points.
Default NURBS curve.
A NURBS curve with Endpoint enabled.
- Order U
The order of the NURBS curve determines the area of influence of the control points over the curve. Higher order values means that a single control point has a greater influence over a greater relative proportion of the curve. The valid range of Order values is 2-6 depending on the number of control points present in the curve.
NURBS curves with orders of 4.
NURBS curves with orders of 2.
- Resolution U
See Common Options.
- Suavizado
See Common Options.