Multiplane Scrape

Référence

Mode

Mode Sculpture

Outil

Toolbar ‣ Multiplane Scrape

Scrapes the mesh with two angled planes at the same time, producing a sharp edge between them. This is useful for creating edges when sculpting hard surface objects.

Paramètres des brosses

Plane Angle

L’angle entre les deux plans de la brosse, en appuyant sur Ctrl inverse l’angle.

Dynamic Mode

When enabled, the base angle is sampled from the mesh surface. The Plane Angle controls how much the angle will increase when applying pen pressure. When pressing Ctrl, it locks the plane angle to 0 degrees.

Show Cursor Preview

Displays a preview of the two scrape planes and the angle they form instead of the cursor while performing the stroke.