Remesh Modifier¶
The Remesh modifier is a tool for generating new mesh topology. The output follows the surface curvature of the input, but its topology contains only quads.
Options¶
The Remesh modifier.¶
- Mode
There are three basic modes available in the Remesh modifier. The output topology is almost identical between the three modes, what changes is the smoothing.
- Blocks
There is no smoothing at all.
- Smooth
Output a smooth surface.
- Sharp
Similar to Smooth, but preserves sharp edges and corners.
- Octree Depth
Sets the resolution of the output. Low values will generate larger faces relative to the input, higher values will generate a denser output.
- Scale
The result can be tweaked further by this, lower values effectively decrease the output resolution.
- Sharpness
Shown when using the Sharp Mode. Higher values produce edges more similar to the input, while lower values filter out noise.
- Smooth Shading
Output faces with smooth shading rather than flat shading. The smooth/flat shading of the input faces is not preserved.
- Remove Disconnected Pieces
Filter out small disconnected pieces of the output.
Thin parts of the input mesh can become lose, and generate small isolated bits of mesh. This option will remove those.
- Threshold
Use this to control how small a disconnected component must be to be removed.
注釈
The input mesh should have some thickness to it. If the input is completely flat, add a Solidify Modifier above the Remesh one.
