Направляющие (guides)
Ссылка
- Режим (mode):
Draw Mode
- Колонтитул:
Guides are drawing aids that make it easier to create different types of strokes. The Guides can be activated with the button next to the selector (grid icon).
Guide Types
Guide selector activated in the 3D Viewport header.
- Circular
Constrains the drawing of new strokes to form rings from the selected reference point.
- Радиально (radial)
Constrains the drawing of new strokes to form rays from the selected reference point.
- Parallel
Constrains the drawing of new strokes to form parallel lines.
- Угол (angle)
Angle direction of the parallel lines.
- Сетка (grid)
Constrains the drawing of new strokes to form parallel horizontal or vertical lines.
- Isometric
Constrains the drawing of new strokes to vertical or isometric lines.
- Угол (angle)
Angle direction of the isometric lines.
Общие параметры
- Use Snapping
When enabled, snap the drawn strokes to an angle or spacing.
- Интервалы (spacing)
Расстояние между направляющими.
- Reference Point
Determines the origin point to use for the creation of the lines. Applies only for Circular and Radial guides.
- Курсор (сursor)
Use the cursor as a reference point.
- Особый (custom)
Use a custom location as a reference point.
- Custom Location
X, Y Z
- Объект (object)
Use an object as a reference point.
- Объект (object)
A Data ID menu to select the object (usually an empty), which location will be used as a reference point.
Примеры
Направляющие Circular. |
Radial Guides. |
Parallel Guides (30° Angle). |
Grid Guides. |