Line Mask

Ссылка

Режим (mode):

Режим скульптинга (sculpt mode)

Инструмент (tool):

Toolbar ‣ Line Mask

This tool creates a Mask across one side of a drawn line. The affected area is visualized by the shaded side of the line.

Использование

Use the tool by:

  1. Orient the 3D Viewport to define the direction in depth.

  2. LMB and hold while moving the cursor to define direction of the line mask.

  3. Adjust the operation with extra Controls shortcuts.

  4. Release LMB to confirm.

Hold Ctrl to subtract from the mask instead.

Элементы управления

Развернуть (flip) F

Changes the side of the line that the tool creates a mask.

Привязать (snap) Ctrl

Ограничивает вращение линии разреза интервалом в 15 градусов.

Move Ctrl-Spacebar

Изменить положение линии.

Настройки панели «Инструмент» (tool settings)

Только лицевая сторона

Only creates a mask on the faces that face towards the view.

Limit to Segment

The affected area will not extend the length of the drawn line. This helps defining a smaller area instead of extending the line infinitely long.