Set Curve Normal Node

The Set Curve Normal controls the method used to calculate curve normals for every curve.

The node doesn’t set the normals directly, those are calculated later as necessary. Combined with the tilt attribute value at each control point, this will define the final normals accessible with the Normal Node.

Internally this node adjusts the values of the normal_mode attribute on each curve.

Inputs

Curve

Standard geometry input, containing curves.

Selection

Whether or not to change the value on each curve.

Properties

Način

The method for evaluation of the curve’s normals

Minumum Twist

The final normals are calculated to have the smallest twist around the curve tangent across the whole curve.

Z-Up

The final normals are calculated so that they is perpendicular to the Z axis and the tangent. If a series of points is vertical, the X axis is used

Outputs

Curve

Standard geometry output.