Sidebar¶
Tool Tab¶
Shows the settings for the active tool.
View Tab¶
Display¶
You can set the editors display options in this panel.
Display panel: With both an image and UVs selected.¶
- Aspect Ratio
Display Aspect for this image. Does not affect rendering.
- Repeat Image
Duplicate the image until it is repeated to fill the main view.
- Pixel Coordinates
Display UV coordinates in pixels rather than from 0.0 to 1.0
2D Cursor¶
- Location X, Y
Control 2D cursor location.
Annotations¶
Options for the annotation tool.
Scopes¶
Scopes in the Image editor.¶
Histogram¶
This mode displays a graph showing the distribution of color information in the pixels of the currently displayed image. The X axis represents values of pixel, from 0 to 1 (or 0 to 255), while the Y axis represents the number of pixels in that tonal range. A predominantly dark image would have most of its information toward the left side of the graph.
Use this mode to balance out the tonal range in an image. A well balanced image should have a nice smooth distribution of color values.
- Luma
Shows the luminosity of an image.
- RGB
Shows the RGB channels stacked on top of each other.
- R/G/B/A
Depending on the channel you choose the scope will show the appropriate channel.
- Show Line
Displays lines rather than filled shapes.
Waveform¶
- Waveform Opacity
Opacity of the points.
- Waveform Mode
- Luma
ToDo.
- YCbCr
ToDo.
- Parade
The RGB channels are shown side-by-side.
- Red Green Blue
Shows the RGB channels overlaid as a «Full color» waveform. It is useful for color grading.
Vectorscope¶
- Vectorscope Opacity
Opacity of the points.
Sample Line¶
The Sample Line scope is the same as the Histogram but allows you to get the sample data from a line.
- Sample Line
Used to draw a line to use to read the sample data from.
Scope Samples¶
- Full Sample
Sample every pixel.
- Accuracy
Proportion of original image source pixel lines to sample.