Sculpt Mode


Toolbar ‣ Fill

Works like the Flatten brush, but only brings vertices below the brush plane upwards.

Brush Settings

Area Radius

Ratio between the brush radius and the radius that is going to be used to sample the area center.

Use Pressure (pressure sensitivity icon)

Uses stylus pressure to control how strong the effect is. The gradient of the pressure can be customized using the curve widget.

Invert to Scrape

When enabled, holding Ctrl while sculpting changes the brush behavior to be the same as the Scrape brush. When disabled, holding Ctrl while sculpting, will push vertices below the cursor downward.