Resample Curve Node

../../../_images/modeling_geometry-nodes_curve_resample-curve_node.png

The Resample Curve node.

The Resample Curve node creates a poly spline for each input spline. In the Count and Length modes, the control points of the new poly splines will have uniform spacing.

ちなみに

Use a field as an input to have a different count/length for each spline.

入力

Curve

Standard geometry input.

Count

The number of control points on the new splines.

Length(長さ)

The approximate length between the control points of the new splines.

ちなみに

A Trim Curve Node can be used with a multiple of the input length to make the distance between each sampled point exact, even when the length of the spline changes.

Properties(プロパティ)

Mode(モード)

How to specify the amount of samples.

Count

Sample the specified number of points along each spline.

Length(長さ)

Calculate the number of samples by splitting each spline into segments with the specified length. The length will be rounded down so that a whole number of samples will fit in each input spline.

Evaluated

Evaluate the spline's points based on the resolution attribute for NURBS and Bézier splines. Changes nothing for poly splines.

出力

Curve

Standard geometry output.