Brush Settings(ブラシ設定)

参照

Mode(モード):

Sculpt Mode(スカルプトモード)

Panel(パネル):

Sidebar ‣ Tool ‣ Brush Settings

Radius(半径)

This option controls the radius of the brush, measured in pixels. F allows you to change the brush size interactively by dragging the mouse and then LMB (the texture of the brush should be visible inside the circle). Typing a number then enter while using F allows you to enter the size numerically.

(Size Pressure)

Adjusts the radius based on the stylus pressure when using a Graphics Tablet.

Strength(強さ)

Controls how much each application of the brush affects the model. For example, higher values cause the Randomize brush to add noise to the strokes more quickly, and cause the Smooth brush to soften the strokes more quickly.

You can change the brush strength interactively by pressing Shift-F in the 3D Viewport and then moving the brush and then LMB. You can enter the size numerically also while in Shift-F sizing.

(Strength Pressure)

Adjusts the strength based on the stylus pressure when using a Graphics Tablet.

Use Falloff

When enabled, use Strength falloff for the brush. Brush Strength decays with the distance from the center of the brush.

Sculpt Strokes

Filters the effect of the brush over the strokes. Applies to Smooth and Randomize brushes only.

注釈

If there is no filter selected Affect Position is the default behavior.

Affect Position

Toggles the brush effect on the position of the stroke points.

Affect Strength

Toggles the brush effect on the strength (alpha) of the stroke points.

Affect Thickness

Toggles the brush effect on the thickness of the stroke points.

Affect UV

Toggles the brush effect on the UV rotation of the stroke points.

Direction(方向)

The influence direction of the brush. This can be Add or Subtract.

高度な設定

Auto-Masking
Strokes

Affect only strokes under the cursor.

Material(マテリアル)

Affect only the active material.

レイヤー

Affect only the active layer.

Cursor(カーソル)

The cursor can be disabled by toggling the checkbox in the Cursor header.

Color(カラー)

Set the color of the brush ring. Depending on the current mode there will be options to set a single Color or a Color for Adding/Subtracting.