Properties

Reference

Mode:Object or Edit Modes
Panel:Properties editor ‣ Metaball

All Meta objects in a scene interact with each other. The settings in the Metaball section apply to all meta objects. In Edit Mode, the Active Element panel appears for editing individual meta elements.

../../_images/modeling_metas_properties_metaball-panel.png

global meta properties.

../../_images/modeling_metas_properties_active-element-panel.png

individual meta properties.

Resolution

The Resolution controls the resolution of the resultant mesh as generated by the Meta object.

View
The 3D View resolution of the generated mesh. The range is from (0.05 to 1.0) (finest to coarsest).
Render
The rendered resolution of the generated mesh. The range is from (0.05 to 1.0) (finest to coarsest).

One way to see the underlying mathematical structure is to lower the Resolution, increase the Threshold and set the Stiffness (see below) a fraction above the Threshold. Fig. Underlying structure. is a Meta cube with the above mentioned configuration applied as follows: Resolution of 0.410, Threshold of 5.0 and Stiffness a fraction above at 5.01.

../../_images/modeling_metas_properties_underlying-structure.png

Underlying structure.

../../_images/modeling_metas_properties_underlying-structure-shape.png

Meta cube shape.

You can clearly see the underlying cubic structure that gives the meta cube its shape.

Threshold (Influence)

Threshold defines how much a meta’s surface «influences» other metas. It controls the field level at which the surface is computed. The setting is global to a group of Meta objects. As the threshold increases, the influence that each meta has on each other increases.

There are two types of influence: positive or negative. The type can be toggled on the Active Element panel while in Edit Mode, using the Negative button. You could think of positive as attraction and negative as repulsion of meshes. A negative meta will push away or repel the meshes of positive Meta objects.

../../_images/modeling_metas_editing_family.png

Positive influence of three meta balls.

A positive influence is defined as an attraction, meaning the meshes will stretch towards each other as the rings of influence intersect. Fig. Positive influence of three meta balls. shows three meta balls“ rings of influence intersecting with a positive influence.

Notice how the meshes have pulled towards one another. The area circled in white shows the green influence rings intersecting.

Update

While transforming metas (grab/move, scale, etc.), you have four «modes» of visualization, located in the Update buttons group of the Metaball panel:

Always
fully draw the meta during transformations.
Half
During transformations, draw the meta at half its Wiresize resolution.
Fast
Do not show meta mesh during transformations.
Never
Never show meta mesh (not a very recommended option, as the meta is only visible at render time!).

This should help you if you experience difficulties (metas are quite computationally intensive…), but with modern computers, this should not happen, unless you use many metas, or very high resolutions…