Grid Fill (заполнение сетки)

Справка

Mode

Режим редактирования

Меню

Face ‣ Grid Fill

Grid Fill uses a pair of connected edge loops or a single, closed edge loop to fill in a grid that follows the surrounding geometry.

The best predictable result can be achieved if you select two opposite edge loops with an equal number of vertices. When a single, closed edge loop is selected, the Span/Offset options allows you to adjust the way two opposite edge loops are detected from one closed edge loop.

Span

Specifies the number of columns in the grid.

Offset (смещение)

Defines the vertex that is considered to be the corner of the grid, by default, it’s the active vertex. The Offset allows you to rotate the grid lines.

Simple Blending

Use a simple interpolation algorithm to generate grid vertices from boundary loops, which does not tries to maintain the shape, useful for flat surfaces or times when keeping the shape gives odd results.

../../../../_images/modeling_meshes_editing_face_grid-fill_before.png

Input.

../../../../_images/modeling_meshes_editing_face_grid-fill_after.png

Grid Fill result.