Chanfro

The Bevel Modifier adds the ability to bevel the edges of the mesh it is applied to, allowing control of how and where the bevel is applied to the mesh.

The Bevel Modifier is a non-destructive alternative to the Bevel Operation in Edit Mode.

../../../_images/modeling_modifiers_generate_bevel_square-not.png

Sem chanfro (ou bisel).
../../../_images/modeling_modifiers_generate_bevel_square.png

Chanfrado (biselado).

The images above show the side views of a plain (not beveled) cube and a beveled one.

Opções

../../../_images/modeling_modifiers_generate_bevel_none-if.png

O painel do modificador Chanfro.

Largura

The size of the bevel affect. See Width Method below.

../../../_images/modeling_modifiers_generate_bevel_cubes.png

Three Cubes with 0.1, 0.3 and 0.5 bevel Widths.

Segmentos
The number of edge loops added along the bevel’s face.
Perfil
The shape of the bevel, from concave to convex. It has no effect if Segments is less than 2.
Materiais
The index of the material slot to use for the bevel. When set to -1, the material of the nearest original face will be used.
Somente vértices

When enabled, only the areas near vertices are beveled; the edges are left not beveled.

../../../_images/modeling_modifiers_generate_bevel_cubes-vertices-only.png

Three cubes with 0.1, 0.3 and 0.5 bevel Widths, with Only Vertices option enabled.

Limitar sobreposições
When enabled, the width of each beveled edge will be limited such that they cannot intersect each other. Edges that are far apart will still bevel with the full width, only edges too close to each other are affected.
Deslizar anéis
If there are unbeveled edges along with beveled edges into a vertex, the bevel tries to slide along those edges when possible. Turning the option off can lead to more even bevel widths.
Método de limitação

Used to control where a bevel is applied to the mesh.

Nenhum
No limit, all edges will be beveled.
Ângulo
Only edges where the adjacent faces form an angle smaller than the defined threshold will be beveled. Intended to allow you to bevel only the sharp edges of an object without affecting its smooth surfaces.
Pesos de influência
Use each edge’s bevel weight to determine the width of the bevel. When the bevel weight is 0.0, no bevel is applied. See here about adjusting bevel weights.
Grupo de vértices
Use weights from a vertex group to determine the width of the bevel. When the vertex weight is 0.0, no bevel is applied. An edge is only beveled if both of its vertices are in the vertex group. See here about adjusting vertex group weights.
Método de largura

Declares how Width will be interpreted to determine the amount of bevel.

../../../_images/modeling_modifiers_generate_bevel_width-methods.png

Métodos de largura.

Deslocamento
Value is interpreted as the distance from the original edge to the edge of the beveled face.
Largura
Value is interpreted as the distance between the two new edges formed by the bevel.
Profundidade
Value is the perpendicular distance from the new bevel face to original edge.
Percentual
Similar to Offset but the value is interpreted as a percentage of the adjacent edge length.