Add Cone

Справка

Mode: Объектный режим и режим редактирования
Tool: Toolbar ‣ Add Cone

Usage

The tool works by first defining the base of the object by holding LMB and dragging to define size of the base. Next release the LMB and drag to define the height of the object. Finally, press LMB again to confirm the shape of the object.

You can also use the hotkeys below to constrain the object.

`Ctrl`	Toggles snapping on or off.
`Alt`	Toggles the Origin setting that is not the default.
`Shift`	Toggles the Aspect setting that is not the default.

Параметры инструмента

Depth

The initial depth used when placing the cursor.

Поверхность: Start placing on the surface, using the 3D cursor as a fallback.
Cursor Plane: Start placement using a point projected onto the orientation axis at the 3D cursor position.
Cursor View: Start placement using a point projected onto the view plane at the 3D cursor position.

Orientation

The alignment of the cursor when placing objects; defines the orientation of the base.

Поверхность: Align the object using the surface orientation, using the Transform Orientations as a fallback.
Default: Align the object using the default Transform Orientations.

Snap To

The target to use while Snapping.

Геометрия: Snap to all types of geometry (vertices, edges, and faces).
Default: Snap to the snap target defined in the global Snapping controls.

Plane Axis

The axis used for placing the base region.

X: Use the X axis to place the base region.
Y: Use the Y axis to place the base region.
Z: Use the Z axis to place the base region.

Auto Axis

Select the closest axis when placing objects (surface overrides).

Base

Origin

The initial position of the base.

Edge (Ребро): Places the object edge first and define the size of the base as the distance from the first edge to the adjacent edge.
Center: Places the object center first and define the size of the base as the distance from the base center to the perimeter.

Aspect

The initial setting for the aspect of the object’s base.

Free: Draws the length and width of the base using an unconstrained aspect.
Фикс: Draws the length and width of the base using a 1:1 aspect.

Высота

Origin

The initial position of the height.

Edge (Ребро): Places the object edge first and define the size of the height as the distance from the first edge to the adjacent edge.
Center: Places the object center first and define the size of the height as the distance from the base center to the perimeter.

Aspect

The initial setting for the aspect of the object’s height.

Free: Draws the length and width of the height using an unconstrained aspect.
Фикс: Draws the length and width of the height using a 1:1 aspect.

Vertices

Число вертикальных рёбер между кругом и остриём, используемые для построения конуса или пирамиды.

Тип заполнения основания (Base Fill Type)

Определяет, как будет заполнена окружность.

Веер треугольников (Triangle Fan): Заполнение из треугольных граней с общей вершиной по середине окружности.
N-gon: Fill with a single N-gon.
Ничего (Nothing): Без заполнения. Создаёт только внешнее кольцо из вершин.