Add Cylinder
Справка
- Mode
Объектный режим и режим редактирования
- Tool
Interactively add a cylinder mesh object.
Usage
The tool works by first defining the base of the object by holding LMB and dragging to define size of the base. Next release the LMB and drag to define the height of the object. Finally, press LMB again to confirm the shape of the object.
You can also use the hotkeys below to constrain the object.
Ctrl |
Toggles snapping on or off. |
Alt |
Toggles the Origin setting that is not the default. |
Shift |
Toggles the Aspect setting that is not the default. |
Параметры инструмента
- Depth
The initial depth used when placing the cursor.
- Поверхность
Start placing on the surface, using the 3D cursor as a fallback.
- Cursor Plane
Start placement using a point projected onto the orientation axis at the 3D cursor position.
- Cursor View
Start placement using a point projected onto the view plane at the 3D cursor position.
- Orientation
The alignment of the cursor when placing objects; defines the orientation of the base.
- Поверхность
Align the object using the surface orientation, using the Transform Orientations as a fallback.
- Default
Align the object using the default Transform Orientations.
- Snap To
The target to use while Snapping.
- Геометрия
Snap to all types of geometry (vertices, edges, and faces).
- Default
Snap to the snap target defined in the global Snapping controls.
- Plane Axis
The axis used for placing the base region.
- X
Use the X axis to place the base region.
- Y
Use the Y axis to place the base region.
- Z
Use the Z axis to place the base region.
- Auto Axis
Select the closest axis when placing objects (surface overrides).
Base
- Origin
The initial position of the base.
- Edge (Ребро)
Places the object edge first and define the size of the base as the distance from the first edge to the adjacent edge.
- Center
Places the object center first and define the size of the base as the distance from the base center to the perimeter.
- Aspect
The initial setting for the aspect of the object’s base.
- Free
Draws the length and width of the base using an unconstrained aspect.
- Фикс
Draws the length and width of the base using a 1:1 aspect.
Высота
- Origin
The initial position of the height.
- Edge (Ребро)
Places the object edge first and define the size of the height as the distance from the first edge to the adjacent edge.
- Center
Places the object center first and define the size of the height as the distance from the base center to the perimeter.
- Aspect
The initial setting for the aspect of the object’s height.
- Free
Draws the length and width of the height using an unconstrained aspect.
- Фикс
Draws the length and width of the height using a 1:1 aspect.
- Vertices
Число вертикальных рёбер между кругом и остриём, используемые для построения конуса или пирамиды.
- Тип заполнения оснований (Cap Fill Type)
Определяет, как будет заполнена окружность.
- Веер треугольников (Triangle Fan)
Заполнение из треугольных граней с общей вершиной по середине окружности.
- N-gon
Fill with a single N-gon.
- Ничего (Nothing)
Без заполнения. Создаёт только внешнее кольцо из вершин.