Шкрябання – Scrape

Reference – Довідка

Mode – Режим

Sculpt Mode – Режим Ліплення

Tool – Засіб

Toolbar ‣ Scrape

The Scrape brush works like the Flatten brush, but only brings vertices above the plane downwards.

Устави Пензля – Brush Settings

Радіус Області – Area Radius

Ratio between the brush radius and the radius that is going to be used to sample the area center.

Вжити Натиск – Use Pressure (іконка чутливості натиску)

Використовує натиск стилуса для керування тим, наскільки сильним є ефект. The gradient of the pressure can be customized using the curve widget.

Інвертувати в Заповнення – Invert to Fill

When enabled, holding Ctrl while sculpting changes the brush behavior to be the same as the Fill brush. When disabled, holding Ctrl while sculpting, will push vertices above the cursor up away from the cursor.