Le modificateur Wireframe

The Wireframe modifier transforms a mesh into a wireframe by iterating over its faces, collecting all edges and turning those edges into four sided polygons. Be aware of the fact that your mesh needs to have faces to be wireframed. You can define the thickness, the material and several other parameters of the generated wireframe dynamically via the given modifier options.

Options

../../../_images/modeling_modifiers_generate_wireframe_panel.png

The Wireframe modifier.

Thickness
The depth or size of the wireframes.
Offset
A value between (-1 to 1) to change whether the wireframes are generated inside or outside of the original mesh. Set to zero, Offset will center the wireframes around the original edges.
Vertex Group

Restreindre le modificateur uniquement à ce groupe de sommets.

Invert
Inverse les poids du groupe de sommets.
Factor
Percentage that the vertex has influence over the final wireframe result.
Crease Edges

This option is intended for usage with the Subdivision modifier. Enable this option to crease edges on their junctions and prevent large curved intersections.

Crease Weight
Define how much crease (0 to 1, nothing to full) the junctions should receive.
Even Thickness
Maintenir l’épaisseur en adaptant les coins aigus. Parfois améliore la qualité mais augmente aussi les temps de calcul.
Relative Thickness
Détermine l’épaisseur de l’arête par la longueur de l’arête. Les arêtes les plus longues seront les plus épaisses.
Boundary
Creates wireframes on mesh island boundaries.
Replace Original
If this option is enabled, the original mesh is replaced by the generated wireframe. If not, the wireframe is generated on top of it.
Material Offset
Uses the chosen material index as the material for the wireframe; this is applied as an offset from the first material.

Avertissement

Wireframe thickness is an approximation. While Even Thickness should yield good results in many cases, skinny faces can cause ugly spikes. In this case you can either reduce the extreme angles in the geometry or disable the Even Thickness option.

Exemples

../../../_images/modeling_modifiers_generate_wireframe_result.jpg

Wireframes sur un plan déplacé.

In this example, the wireframes carry a second (dark) material while the displaced plane uses its original one.

../../../_images/modeling_modifiers_generate_wireframe_example-weights.png

Pesée du groupe de sommets.

Les poids de ce groupe de sommets change graduellement de 0 à 1.

../../../_images/modeling_modifiers_generate_wireframe_example-crease.png

Modificateurs Wireframe et Subdivision Surface.

Cube avec l’option Crease Edges activée. Le Crease Weight est défini à 0.5 et 1.