Reestruturar malha¶
The Remesh modifier is a tool for generating new mesh topology. The output follows the surface curvature of the input, but its topology contains only quads.
Opções¶
- Modo
There are three basic modes available in the Remesh modifier. The output topology is almost identical between the three modes, what changes is the smoothing.
- Blocos
- Não há suavização como um todo.
- Suavizar
- Gera a saída de uma superfície suavizada.
- Acentuado
- Similar to Smooth, but preserves sharp edges and corners.
- Profundidade da árvore de octetos
- Sets the resolution of the output. Low values will generate larger faces relative to the input, higher values will generate a denser output.
- Escalonamento
- The result can be tweaked further by this, lower values effectively decrease the output resolution.
- Acuidade
- Shown when using the Sharp Mode. Higher values produce edges more similar to the input, while lower values filter out noise.
- Suavização de sombreamento
- Output faces with smooth shading rather than flat shading. The smooth/flat shading of the input faces is not preserved.
- Remover as peças desconectadas
Filter out small disconnected pieces of the output.
Thin parts of the input mesh can become lose, and generate small isolated bits of mesh. This option will remove those.
- Ajuste
- Use this to control how small a disconnected component must be to be removed.
Nota
The input mesh should have some thickness to it. If the input is completely flat, add a Solidify Modifier above the Remesh one.