Add Cylinder¶
Référence
- Mode
Mode Objet et Mode Édition
- Outil
Ajouter de manière interactive un cylinder mesh object.
Utilisation¶
The tool works by first defining the base of the object by holding LMB and dragging to define size of the base. Next release the LMB and drag to define the height of the object. Finally, press LMB again to confirm the shape of the object.
You can also use the hotkeys below to constrain the object.
Ctrl |
Toggles snapping on or off. |
Alt |
Toggles the Origin setting that is not the default. |
Maj |
Toggles the Aspect setting that is not the default. |
Paramètres de l’outil¶
- Depth
The initial depth used when placing the cursor.
- Surface
Start placing on the surface, using the 3D cursor as a fallback.
- Cursor Plane
Start placement using a point projected onto the orientation axis at the 3D cursor position.
- Cursor View
Start placement using a point projected onto the view plane at the 3D cursor position.
- Orientation
The alignment of the cursor when placing objects; defines the orientation of the base.
- Surface
Align the object using the surface orientation, using the Transform Orientations as a fallback.
- Default
Align the object using the default Transform Orientations.
- Snap To
La cible à utiliser pendant Snapping (Accrochage).
- Geometry
Accrochage à tous les types de géométrie (sommets, arêtes et faces).
- Default
Snap to the snap target defined in the global Snapping (Accrochage) controls.
- Plane Axis
The axis used for placing the base region.
- X
Use the X axis to place the base region.
- Y
Use the Y axis to place the base region.
- Z
Use the Z axis to place the base region.
- Auto Axis
Select the closest axis when placing objects (surface overrides).
Base
- Origin
The initial position of the base.
- Edge
Places the object edge first and define the size of the base as the distance from the first edge to the adjacent edge.
- Center
Places the object center first and define the size of the base as the distance from the base center to the perimeter.
- Aspect
The initial setting for the aspect of the object’s base.
- Libre
Draws the length and width of the base using an unconstrained aspect.
- Fixed
Draws the length and width of the base using a 1:1 aspect.
Height
- Origin
The initial position of the height.
- Edge
Places the object edge first and define the size of the height as the distance from the first edge to the adjacent edge.
- Center
Places the object center first and define the size of the height as the distance from the base center to the perimeter.
- Aspect
The initial setting for the aspect of the object’s height.
- Libre
Draws the length and width of the height using an unconstrained aspect.
- Fixed
Draws the length and width of the height using a 1:1 aspect.
- Vertices
Le nombre d’arêtes verticales entre les cercles ou la pointe, utilisé pour définir le cône ou la pyramide.
- Cap Fill Type
Définir la manière dont le cercle est rempli.
- Triangle Fan
Remplir avec des faces triangulaires qui ont un sommet commun au centre.
- N-gon
Remplir avec un simple N-gon.
- Nothing
Ne pas remplir. Crée seulement l’anneau de sommets externe.