Line Project
Ссылка
- Режим
Режим скульптинга (sculpt mode)
- Инструмент (tool)
This tool flattens the geometry along a plane determined by the camera view and a drawn line. The region of the mesh being flattened is visualized by the side of the line that is shaded.
Настройки инструмента
- Limit to Segment
Apply the gesture action only to the area that is contained within the segment without extending its effect to the entire line.
Использование
Orient the 3D Viewport to define the local view plane to use for the Boolean.
LMB and hold while moving the cursor to define the line to pick a region of the view plane to remove.
Release LMB to confirm.
Элементы управления
- Flip F
Changes the side of the line that the tool removes geometry.
- Snap (Привязка) Ctrl
Ограничивает вращение линии разреза интервалом в 15 градусов.
- Move Ctrl-Spacebar
Изменение расположения линии разреза.
Пример
![]() Before Line Project. |
![]() After Line Project. |