Suy Giảm Dần (Falloff)
The Falloff allows you to control the Strength falloff of the brush. The falloff is mapped from the center of the brush (left part of the curve) towards its borders (right part of the curve). Changing the shape of the curve will make the brush softer or harder. Read more about using the Thành tố đường cong (Curve Widget).
Ví dụ về đẩy trồi.
- Sắp Đặt Sẵn của Đường Cong (Curve Preset)
- Tùy Chỉnh (Custom)
You can choose how the strength of the falloff is determined from the center of the brush to the borders by manually manipulating the control points within the curve widget. There are also a couple of preset custom curves displayed at the bottom of the curve widget that can be used on their own or as a starting point for tweaking.
Các Thể Loại Tùy Chọn Sắp Đặt Sẵn. (Custom Preset types.) 
Làm Mịn/Trơn Tru.
Hình Cầu.
Phép Căn.
Đột Ngột.
Tuyến Tính.
Hằng Số/Đồng Đều/Bất Biến.
- Mịn Màng (Smooth)
The center strength, the border strength, and the falloff transition between them are evenly distributed.
- Mịn Hơn (Smoother)
Similar to Smooth but produces a wider center point of the brush before tapering off.
- Hình Cầu (Sphere)
The strength of the brush is predominately at its strongest point with a steep falloff near the border of the brush.
- Gốc/Phép Căn (Root)
Similar to a Sphere but the center is a more concentrated point.
- Sắc Nhọn/Đột Ngột (Sharp)
The center of the brush is the strongest point then exponentially tapers off to a lower strength, creating a fine point.
- Tuyến Tính (Linear)
With the center being the strongest, the strength will consistently weaken as it reaches the border of the brush.
- Sắc Nhọn Hơn (Sharper)
Similar to Sharp but the center point is more condensed.
- Đảo Nghịch Bình Phương (Inverse Square)
A hybrid between Smooth and Sphere.
- Hằng Số/Đồng Đều/Bất Biến (Constant)
The strength of the brush remains unified across the entire brush. This will create a sharp edge at the border of the brush.
(From Left to Right) Smooth, Smoother, Sphere, Root, Sharp, Linear, Sharper, Inverse square, Constant.
- Hình Dạng của sự Suy Giảm Dần (Falloff Shape)
Use projected or spherical falloff. Note, this is not supported in Texture Paint Mode.
- Hình Cầu (Sphere)
Applies brushes influence in a sphere, outwards from the center.
- Dự Phóng (Projected)
This turns the brush influence into a cylinder (the depth along the view is ignored) instead of a sphere. It can be used along the outline of a mesh to adjust its silhouette.
Suy Giảm Dần theo pháp tuyến (Normal Falloff)
As faces point away from the view the brush strokes fade away to prevent harsh edges.
- Góc Độ (Angle)
The angle at which the falloff begins.