Agregar esfera
Referencia
- Modo
Modo Objeto y Edición
- Herramienta
Agrega interactivamente un objeto de malla de esfera.
Uso
The tool works by first defining the base of the object by holding LMB and dragging to define size of the base. Next release the LMB and drag to define the height of the object. Finally, press LMB again to confirm the shape of the object.
You can also use the hotkeys below to constrain the object.
Ctrl |
Toggles snapping on or off. |
Alt |
Toggles the Origin setting that is not the default. |
Mayús |
Toggles the Aspect setting that is not the default. |
Opciones de herramientas
- Profundidad
The initial depth used when placing the cursor.
- Superficie
Start placing on the surface, using the 3D cursor as a fallback.
- Cursor 3D plano
Start placement using a point projected onto the orientation axis at the 3D cursor position.
- Cursor 3D vista
Start placement using a point projected onto the view plane at the 3D cursor position.
- Orientación
The alignment of the cursor when placing objects; defines the orientation of the base.
- Superficie
Align the object using the surface orientation, using the Orientación de transformación as a fallback.
- Predefinido
Align the object using the default Orientación de transformación.
- Adherir a
El objetivo a utilizar al Adherencia.
- Geometría
Adhiere a todos los tipos de geometría (vértices, bordes y caras).
- Predefinido
Snap to the snap target defined in the global Adherencia controls.
- Eje del plano
The axis used for placing the base region.
- X
Use the X axis to place the base region.
- Y
Use the Y axis to place the base region.
- Z
Use the Z axis to place the base region.
- Eje automático
Select the closest axis when placing objects (surface overrides).
Base
- Orígenes
The initial position of the base.
- Borde
Places the object edge first and define the size of the base as the distance from the first edge to the adjacent edge.
- Centro
Places the object center first and define the size of the base as the distance from the base center to the perimeter.
- Proporción
The initial setting for the aspect of the object’s base.
- Libre
Draws the length and width of the base using an unconstrained aspect.
- Fijo
Draws the length and width of the base using a 1:1 aspect.
Altura
- Orígenes
The initial position of the height.
- Borde
Places the object edge first and define the size of the height as the distance from the first edge to the adjacent edge.
- Centro
Places the object center first and define the size of the height as the distance from the base center to the perimeter.
- Proporción
The initial setting for the aspect of the object’s height.
- Libre
Draws the length and width of the height using an unconstrained aspect.
- Fijo
Draws the length and width of the height using a 1:1 aspect.
- Segmentos
Número de segmentos verticales. Como los meridianos de la Tierra, van de polo a polo.
- Anillos
Número de segmentos horizontales. Estos son como los paralelos de la Tierra.
Nota
Los anillos son bucles de caras y no de bordes, que serían uno menos.