Vẽ

Tham Chiếu

Chế Độ

Chế Độ Biên Soạn

Công Cụ

Xương (Bone) ‣ Biến Dạng (Deform)

The Curve draw tool allows you to free-hand draw curves.

Sắp Đặt Công Cụ

../../../_images/modeling_curves_tools_draw_curve-stroke-panel.png

Curve Stroke panel.

Thể Loại

Type of curve to use for drawing.

Đa Giác

Bézier Curve with straight line segments (auto handles).

Đường Cong Bézier -- Bézier
Sai Số

Lower values give a result that is closer to the drawing stroke, while higher values give more smoothed results.

Phương Pháp
Tái Khớp/Chỉnh Lại

Incrementally refits the curve (gives best results).

Tách Phân

Splits the curve until the tolerance is met (gives a better drawing performance).

Phát Hiện các Góc

Detects corners while drawing based on a specified angle; Any angles above the specified value are considered corners. If a corner is detected, the curve uses non-aligned handles for the corner resulting in a more crisp corner.

Bán Kính
Mức/Độ Tối Thiểu

Minimum radius when the minimum pressure is applied (also the minimum when tapering).

Tối Đa

Radius to use when the maximum pressure is applied (or when a tablet is not used).

Sử Dụng Áp Lực

Uses stylus pressure to control the radius of the curve.

Chiều/Độ Sâu

Controls where and how the curves are drawn.

Con Trỏ

Uses the depth under the cursor to draw curves.

Bề Mặt

Used to draw on top of other objects.

Dịch Chuyển

Distance to offset the curve from the surface.

Dịch Chuyển Tuyệt Đối

Applies a fixed offset (does not scale by the curve radius).

Duy Điểm Đầu

Only uses the start of the stroke for the depth.

Mặt Phẳng

The orientation plane to draw on, available when Only First is enabled.

Pháp Tuyến/Góc Nhìn

Draws perpendicular to the surface.

Pháp Tuyến/Bề Mặt

Draws aligned to the surface.

Góc Nhìn

Draws aligned to the viewport.

Tùy Chọn

After the tool is run, these options are available in the Điều Chỉnh Thao Tác Trước Đây panel.

Lỗi/Sai Số

Error distance in object units. This can be seen similar to a subdivision rate for the curve. Lower values give a result that is closer to the drawing stroke while higher values give more smoothed results.

Phương Pháp Khít
Tái Khớp/Chỉnh Lại

Incrementally refits the curve (gives best results).

Tách Phân

Splits the curve until the tolerance is met (gives a better drawing performance).

Góc Độ của Đỉnh

Any angles above this are considered corners.

Tuần Hoàn

Toggles whether or not the curve is Cyclic.