Đường cong spline đang hoạt động
Tham Chiếu
- Chế Độ
Chế Độ Biên Soạn
- Trình Đơn
The Active Spline panel is used in Edit Mode to control properties of the currently selected spline.
Tùy Chọn Chung
- Tuần Hoàn U
Closes the active spline.
Default NURBS curve.
A NURBS curve with Cyclic applied.
- Độ Phân Giải U
Alters the resolution of each segment by changing the number of subdivisions.
- Làm Mịn/Trơn Tru
Sử dụng Tô Bóng Mịn Màng -- Smooth Shading cho mọi hình học 3D.
Đa Giác

Active Spline panel: Poly Spline.
- Tuần Hoàn U
See Common Options.
- Làm Mịn/Trơn Tru
See Common Options.
Đường Cong Bézier -- Bézier

Active Spline panel: Bézier Spline.
- Tuần Hoàn U
See Common Options.
- Độ Phân Giải U
See Common Options.
- Nội Suy sự Xoay Nghiêng
Alters how the tilt of a segment is calculated.
- Bán Kính
Alters how the radius of a beveled curve is calculated. The effects are easier to see after increasing the radius.
- Làm Mịn/Trơn Tru
See Common Options.
NURBS
One of the characteristics of a NURBS object is the knot vector. This is a sequence of numbers used to determine the influence of the control points on the curve. While you cannot edit the knot vectors directly, you can influence them through the Endpoint and Bézier options in the Active Spline panel. Note that, the Endpoint and Bézier settings only apply to open NURBS curves.

Active Spline: NURBS Spline.
- Tuần Hoàn U
See Common Options.
- Bézier U
Makes the NURBS curve act like a Bézier curve. The NURBS control points act like Free handles of Bézier curve. Depending on the Order, 3 or 4 control points form one curve segment. Cyclic and Endpoint must be disabled for this option to work.
- Điểm Kết Thúc U
Makes the curve contact the end control points. Cyclic must be disabled for this option to work.
Default NURBS curve.
A NURBS curve with Endpoint enabled.
- Bậc chiều U
The order of the NURBS curve determines the area of influence of the control points over the curve. Higher order values means that a single control point has a greater influence over a greater relative proportion of the curve. The valid range of Order values is 2-6 depending on the number of control points present in the curve.
NURBS curves with orders of 4.
NURBS curves with orders of 2.
- Độ Phân Giải U
See Common Options.
- Làm Mịn/Trơn Tru
See Common Options.