Vòng Mạch Phân Chia (Loop Cut)

Tham Chiếu (Reference)

Chế Độ (Mode)

Chế Độ Biên Soạn (Edit Mode)

Công Cụ (Tool)

Toolbar ‣ Loop Cut

Tổ Hợp Phím Tắt (Shortcut)

Ctrl-R

The Loop Cut tool is a modal tool version of the Vòng Mạch Phân Chia và Trượt Đẩy (Loop Cut and Slide) operator. This tool splits a loop of faces by inserting new edge loops intersecting the chosen edge.

Cách Sử Dụng (Usage)

The tool is interactive and has two steps:

  1. Pre-Visualizing the Cut

    After the tool is activated, move the cursor over a desired edge. The cut to be made is marked with a magenta colored line as you move the mouse over the various edges. The to be created edge loop stops at the poles (tris and n-gons) where the existing face loop terminates.

  2. Thi hành cắt

    Once the desired location of the new edge loop is found, the edge loop can be created via LMB.

../../../_images/modeling_meshes_tools_loop_before.png

Mesh before inserting edge loop.
../../../_images/modeling_meshes_tools_loop_preview.png

Preview of edge loop location.
../../../_images/modeling_meshes_tools_loop_placement.png

Interactive placement of edge loop between adjacent loops.

Sắp Đặt Công Cụ (Tool Settings)

Số phân đoạn (Number of Cuts)

Increases and decreases the number of cuts to create. These cuts are uniformly distributed in the original face loop, and you will not be able to control their positions.

Chỉnh Sửa UV (Correct UVs)

Corrects the corresponding UV coordinates, if these exist, to avoid image distortions.

Tùy Chọn (Options)

After the modal tool is run the Loop Cut and Slide Options are available in the Điều Chỉnh Thao Tác Trước Đây (Adjust Last Operation) panel.