Giao Cắt [Dao] (Intersect [Knife])
Tham Chiếu (Reference)
- Chế Độ (Mode)
Chế Độ Biên Soạn (Edit Mode)
- Trình Đơn (Menu)
The Intersect tool lets you cut intersections into geometry. It is a bit like the Boolean tool, but, does not calculate interior/exterior geometry. Faces are split along the intersections, leaving new edges selected.
- Nguồn (Source)
- Tự Giao Cắt (Self Intersect)
Operate on the overlapping geometry of the mesh.
- Chọn/Chưa Chọn (Selected/Unselected)
Operate between the selected and unselected geometry.
- Chế Độ Tách Phân (Separate Mode)
- Toàn Bộ (All)
Splits the geometry at the new edge.
- Cắt (Cut)
Keep each side of the intersection separate without splitting the faces in half.
- Hội Nhập (Merge)
Merge all the geometry from the intersection.
- Trình Giải Nghiệm (Solver)
Algorithm used to calculate the intersections.
- Nhanh (Fast)
Uses a mathematically simple solver which offers the best performance; however, this solver lacks support for overlapping geometry.
- Ngưỡng hội nhập (Merge Threshold)
Tolerance for close faces to be considered touching. It may be useful to increase this when some intersections aren't detected that should be and when extra geometry is being created because edges aren't detected as overlapping.
Cảnh báo
A threshold approaching the size of faces may cause very slow calculation, in general keep this value small.
- Chính Xác (Exact)
Uses a mathematically complex solver which offers the best results and has full support for overlapping geometry; however, this solver is much slower than the Fast Solver.