Chọn Toàn Bộ theo Đặc Điểm (Select All by Trait)

Phi đa tạp (Non-Manifold)

Tham Chiếu (Reference)

Chế Độ (Mode): Chế Độ Biên Soạn (Edit Mode)
Trình Đơn (Menu): Select ‣ Select All by Trait ‣ Non-Manifold

Selects the Non-manifold geometry of a mesh. This entry is available when editing a mesh, in Vertex and Edge selection modes only.

Nới/Mở Rộng (Extend): Lets you extend the current selection.
Mạch Lưới (Wire): Selects all the edges that do not belong to any face.
Ranh Giới (Boundaries): Selects edges in boundaries and holes.
Đa Bề Mặt (Multiple Faces): Selects edges that belong to three or more faces.
Không Tiếp Giáp (Non Contiguous): Selects edges that belong to exactly two faces with opposite normals.
Vertices (Điểm Đỉnh): Selects vertices that belong to wire and multiple face edges, isolated vertices, and vertices that belong to non-adjoining faces.

Hình Học Rời Rạc (Loose Geometry)

Tham Chiếu (Reference)

Chế Độ (Mode): Chế Độ Biên Soạn (Edit Mode)
Trình Đơn (Menu): Select ‣ Select All by Trait ‣ Loose Geometry

This selection depends on the currently selected Selection Modes; In vertex and edge selection mode it selects all vertices or edges that do not form part of a face. In face selection mode it selects all faces that do not share edges with other faces.

Bề Mặt Bên Trong (Interior Faces)

Tham Chiếu (Reference)

Chế Độ (Mode): Chế Độ Biên Soạn (Edit Mode)
Trình Đơn (Menu): Select ‣ Select All by Trait ‣ Interior Faces

Selects faces where all edges have more than two faces.

Bề Mặt Theo Số Cạnh (Faces by Sides)

Tham Chiếu (Reference)

Chế Độ (Mode): Chế Độ Biên Soạn (Edit Mode)
Trình Đơn (Menu): Select ‣ Select All by Trait ‣ Faces by Sides

Selects all faces that have a specified number of edges.

Điểm Đỉnh Chưa Nhóm (Ungrouped Vertices)

Tham Chiếu (Reference)

Chế Độ (Mode): Chế Độ Biên Soạn (Edit Mode)
Trình Đơn (Menu): Select ‣ Select All by Trait ‣ Ungrouped Vertices

Selects all vertices which are not part of a vertex group.