Color Correction Node¶

The Color Correction node adjusts the color of an image, separately in several tonal ranges (highlights, midtones and shadows).

Inputs¶

These settings target the entire tonal range.

Saturation: Adjusts the image’s saturation.
Contrast: Adjust image contrast.
Gamma: Exponential gamma correction, affecting the midtones of the image. (Works like Power in the Color Balance node.)
Gain: Multiplier, stronger influence on the highlights. (Works like Slope in the Color Balance node.)
Lift: This value (can be negative) will be added (+), linear lightens or darkens the image. (Works like Offset in the Color Balance node.)

These settings target specific brightness ranges of the image.

Each tonal range (Highlights, Midtones, Shadows) supports the same controls as Master.

Midtones Start, Midtones End: Defines the start and the end of midtones range, i.e. values where the whole tonal range is divided into the highlights, midtones and shadows (there is also a smooth transition between the ranges of width 0.2 units).

Red, Green, Blue: Specifies which RGB channels will be affected by the correction.

This node has no properties.