Bounding Box Center – Центр Габаритної Коробки

Reference – Довідка

Mode – Режим:

Object Mode and Edit Mode – Режим Об’єкта та Режим Редагування

Header – Заголовок:

Pivot Point ‣ Bounding Box Center – «Точка Опертя > Центр Габаритної Коробки»

Shortcut – Шоткат:

Period

In this mode, the pivot point lies at the center of the bounding box, which is a box that’s wrapped as tightly as possible around the selection while still being aligned to the world axes.

In Object Mode – У Режимі Об’єкта

The pivot point becomes the center of the bounding box around the selected objects“ origin points, not their geometry.

This means that, if you have a single object selected, the pivot point is the same as the object’s origin point – which can be customized and doesn’t have to be in the center. In the example below, the orange rectangle has it in a corner instead.

Обертання одиничного об’єкта.

If you have multiple objects selected, the pivot point becomes the center of an imaginary box around their origins.

The image below shows the difference between Bounding Box Center and Median Point – Серединна Точка. The latter calculates the average position of the origins, meaning that the pivot point shifts towards the area with the most objects.

Difference between «Bounding Box Center» (left) and «Median Point» (right).

In Edit Mode – У Режимі Редагування

The pivot point becomes the center of the bounding box around the selected mesh elements.

The effects of rotation in different mesh selection modes. The pivot point is shown by a yellow circle.

Median Point may again give a different result.

Difference between «Bounding Box Center» (left) and «Median Point» (right).