Extrude Faces Along Normals (Vlakken Langs Normalen Extruderen)

Reference (Referentie)

Mode (Modus):

Edit Mode (Bewerkingsmodus)

Tool (Tool):

Toolbar ‣ Extrude Along Normals

Menu:

Face ‣ Extrude Faces Along Normals, Mesh ‣ Extrude ‣ Extrude Faces Along Normals

This tool is similar to Extrude Face (Vlakken Extruderen), but instead of moving all vertices along the same axis, it moves each vertex along its normal. This means an outward extrusion on a convex surface will make the faces larger, for example.

Before extrusion

Regular extrusion

Extrusion along normals

After extruding, the following options are available in the Adjust Last Operation (Laatste operatie aanpassen) panel:

Flip Normals (Normalen Omkeren)

Flip the normals of the newly created faces, as they might be pointing the wrong way depending on the extrusion direction. See the Face Orientation overlay of the 3D Viewport to check whether they are correct.

Dissolve Orthogonal Edges (Oplossen Orthogonale Randen)

When enabled, newly created faces will be merged with surrounding existing faces (potentially turning them into n-gons) if they form a flat surface together.

Offset (Offset)

Distance to move the vertices.

Offset Even (Evenwijdige Verschuiving)

When disabled, each vertex is offset by the same distance. When enabled, each face is offset by the same distance.

This option can also be toggled while extruding by pressing S or holding Alt. (These shortcuts are shown in the status bar.)

Before extrusion

Offset Even off (default)

Offset Even on

Mirror Editing (Gespiegeld Bewerken)

Enabling this option moves the corresponding vertices on the other side of the mesh without extruding any faces, making it not very useful here.

Proportional Editing

Enabling this option also moves the surrounding unselected vertices along their normals, making it not very useful for extrusion.

Zie ook

Shrink/Flatten (Krimp/Platmaken) for moving vertices along their normal without extruding.